Product SiteDocumentation Site

4.2.3. Channel Bonding Interfaces

Fedora allows administrators to bind multiple network interfaces together into a single channel using the bonding kernel module and a special network interface called a channel bonding interface. Channel bonding enables two or more network interfaces to act as one, simultaneously increasing the bandwidth and providing redundancy.
To create a channel bonding interface, create a file in the /etc/sysconfig/network-scripts/ directory called ifcfg-bond<N> , replacing <N> with the number for the interface, such as 0.
The contents of the file can be identical to whatever type of interface is getting bonded, such as an Ethernet interface. The only difference is that the DEVICE= directive must be bond<N> , replacing <N> with the number for the interface.
The following is a sample channel bonding configuration file:
DEVICE=bond0
BONDING_OPTS="mode=1 miimon=500"
BOOTPROTO=none
ONBOOT=yes
NETWORK=10.0.1.0
NETMASK=255.255.255.0
IPADDR=10.0.1.27
USERCTL=no

After the channel bonding interface is created, the network interfaces to be bound together must be configured by adding the MASTER= and SLAVE= directives to their configuration files. The configuration files for each of the channel-bonded interfaces can be nearly identical.
For example, if two Ethernet interfaces are being channel bonded, both eth0 and eth1 may look like the following example:
DEVICE=eth<N>
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no

In this example, replace <N> with the numerical value for the interface.

Important

Important aspects of the channel bonding interface are controlled through the kernel module. For more information about controlling the bonding modules, refer to Section 30.5.2, “The Channel Bonding Module”.