Product SiteDocumentation Site

2.3. Installing guests with PXE

This section covers the steps required to install guests with PXE. PXE guest installation requires a shared network device, also known as a network bridge. The procedures below cover creating a bridge and the steps required to utilize it the bridge for a PXE installation.
  1. Create a new bridge

    1. Create a new network script file in the /etc/sysconfig/network-scripts/ directory. This example creates a file named ifcfg-installation which makes a bridge named installation
      # cd /etc/sysconfig/network-scripts/
      # vim ifcfg-installation


      The line, TYPE=Bridge, is case-sensitive. It must have uppercase 'B' and lower case 'ridge'.
    2. Start the new bridge.
      # ifup installation
    3. There are no interfaces added to the new bridge yet. Use the brctl show command to view details about network bridges on the system.
      # brctl show
      bridge name     bridge id               STP enabled     interfaces
      installation    8000.000000000000       no
      virbr0          8000.000000000000       yes
      The virbr0 bridge is the default bridge used by libvirt for Network Address Translation (NAT) on the default Ethernet device.
  2. Add an interface to the new bridge

    Edit the configuration file for the interface. Add the BRIDGE parameter to the configuration file with the name of the bridge created in the previous steps.
    # Intel Corporation Gigabit Network Connection
    After editing the configuration file, restart networking or reboot.
    # service network restart
    Verify the interface is attached with the brctl show command:
    # brctl show
    bridge name     bridge id               STP enabled     interfaces
    installation    8000.001320f76e8e       no              eth1
    virbr0          8000.000000000000       yes
  3. Security configuration

    Configure iptables to allow all traffic to be forwarded across the bridge.
    # iptables -I FORWARD -m physdev --physdev-is-bridged -j ACCEPT
    # service iptables save
    # service iptables restart

    Disable iptables on bridges

    Alternatively, prevent bridged traffic from being processed by iptables rules. In /etc/sysctl.conf append the following lines:
    net.bridge.bridge-nf-call-ip6tables = 0
    net.bridge.bridge-nf-call-iptables = 0
    net.bridge.bridge-nf-call-arptables = 0
    Reload the kernel parameters configured with sysctl
    # sysctl -p /etc/sysctl.conf
  4. Restart libvirt before the installation

    Restart the libvirt daemon.
    # service libvirtd reload
The bridge is configured, you can now begin an installation.
PXE installation with virt-install
For virt-install append the --network=bridge:BRIDGENAME installation parameter where installation is the name of your bridge. For PXE installations use the --pxe parameter.
# virt-install --accelerate --hvm --connect qemu:///system \
    --network=bridge:installation --pxe\
    --name EL10 --ram=756 \
    --os-type=linux --os-variant=rhel5
    --file=/var/lib/libvirt/images/EL10.img \

Example 2.3. PXE installation with virt-install

PXE installation with virt-manager
The steps below are the steps that vary from the standard virt-manager installation procedures. For the standard installations refer to Chapter 3, Guest operating system installation procedures.
  1. Select PXE

    Select PXE as the installation method.
  2. Select the bridge

    Select Shared physical device and select the bridge created in the previous procedure.
  3. Start the installation

    The installation is ready to start.
A DHCP request is sent and if a valid PXE server is found the guest installation processes will start.