Product SiteDocumentation Site

9.15. The Configuration Menu and Progress Screen

Once you click Begin Installation on the Installation Summary Menu, you will be directed to the Configuration Menu and Progress Screen. Fedora reports the installation progress on the screen as it writes the selected packages to your system.
Installing packages
The Packages Completed progress bar
Figure 9.25. Installing packages

For your reference, a complete log of your installation can be found in /root/install.log once you reboot your system.
While the packages are being installed, more configuration is required. Above the installation progress bar is the Root Password menu item. The root password can be configured either while the packages are being installed or afterwards, but you will not be able to complete the installation process until it has been configured.

9.15.1. Set the Root Password

Setting up a root account and password is one of the most important steps during your installation. The root account is used to install packages, upgrade RPMs, and perform most system maintenance. Logging in as root gives you complete control over your system.

Note

The root user (also known as the superuser) has complete access to the entire system; for this reason, logging in as the root user is best done only to perform system maintenance or administration.
Root Password
Setting your root password.
Figure 9.26. Root Password

Use the root account only for system administration. Create a non-root account for your general use and use the su command to change to root only when you need to perform tasks that require superuser authorization. These basic rules minimize the chances of a typo or an incorrect command doing damage to your system.

Note

To become root, type su - at the shell prompt in a terminal window and then press Enter. Then, enter the root password and press Enter.
The installation program requires you to set a root password[4] for your system. . You cannot proceed to the installation itself without entering a root password.
The root password must be at least six characters long; the password you type is not echoed to the screen. You must enter the password twice; if the two passwords do not match, the installation program asks you to enter them again.
You should make the root password something you can remember, but not something that is easy for someone else to guess. Your name, your phone number, qwerty, password, root, 123456, and anteater are all examples of bad passwords. Good passwords mix numerals with upper and lower case letters and do not contain dictionary words: Aard387vark or 420BMttNT, for example. Remember that the password is case-sensitive. If you write down your password, keep it in a secure place. However, it is recommended that you do not write down this or any password you create.

Note

Do not use one of the example passwords offered in this manual. Using one of these passwords could be considered a security risk.
To change your root password after you have completed the installation, use the Root Password Tool.
Type the system-config-users command in a shell prompt to launch the User Manager, a powerful user management and configuration tool. If you are not root, it prompts you for the root password to continue.
Click the Root Password menu item and enter your nominated password into the Root Password field. Fedora displays the characters as asterisks for security. Type the same password into the Confirm field to ensure it is set correctly. After you set the root password, click Done to return to the Configuration Menu and Progress Screen.


[4] A root password is the administrative password for your Fedora system. You should only log in as root when needed for system maintenance. The root account does not operate within the restrictions placed on normal user accounts, so changes made as root can have implications for your entire system.